Carbide tipped saw blades
Below is just a selection of our carbide tipped saw blade line.
Standard rip saw blades with or without wiper slots (strobe slots) for cutting heavy sections of wet or dry lumber. Offered with or without chip limiters. For single or multiple rip saws.
Glue joint rip saw blades for perfect glue joints in soft or hard woods, especially suited for straight line rip saws.
Radial arm / pendulum saw blades are offered in positive or negative hook angle. Negative hook angles are less likely to "grab", making hand operation easier and safer.
Combination saw blades are our general purpose saw blades. This blade will rip, crosscut and miter solid wood as well as cut particleboard and plywood.
Cut-off saw blades with alternate op level (ATB) for cutting solid wood, plywood, veneers and veneered board. Certain sizes offered in metric.
Cut-off saw blades with Triple chip grind (TCG) are used to cut more abrasive materials such as plastic, Melamine and paper laminated board, including countertops. Certain sizes offered in metric.
Melamine and solid surface cutting saw blades are mostly used on machines without a scoring attachment. Available in high ATB and TCG with negative hook angle for a perfect finish on top and bottom of board.
Double-end trim saw blades produce exceptionally fine trim cuts on the trim station of double end tenoners with this 3+1 tooth design.
Miter joint saw blades come with a 20 degree ATB plus special hook and grind which produces a smooth, trim miter cut on moldings, picture frames and other furniture parts where angle cut finishes are critical.
Thin-kerf and thin-rim saw blades in ATB and TCG grind for perfect cuts in thin materials.
Panel sizing with matching scoring saw blades are produced for all modern panel-sizing systems on the market. Gabbiani, Giben, Holzma, Mayer, Scheer, SCMI, Selco, etc.
Tapered and 2 piece adjustable scoring saw blades for use on rolling table saws and other saws with scoring units.
Plastic cutting saw blades are designed and recommended to cut single and multiple sheets of acrylics, PVC and other plastic materials where chipping and melting is a concern.
Nonferrous cutting saw blades to cut aluminium and other non-ferrous profiles, tubing and solid sections.
Steel cutting saw blades are designed to cut steel and composite materials with metal coverings. To be used on special cut-off machines such as Jepson. Using the right RPM is critical.
Dado sets are designed for grooving with or across the grain. For solid wood, veneers, melamine and other laminates.
Edge banding / Edge clipping saw blades for use on all popular edge banding machines.
Custom-made saw blades . Outils Bo-Scie can produce saw blades to your specific requirements in sizes from 4" to 40" inches in diameter.